Nd Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP FlexFabric 12500 Series Configuration Manual

ND MAD-enabled IRF configuration example for a two-chassis
IRF fabric
Network requirements
As shown in
Configure ND MAD for the IRF fabric and use Device C as an intermediate device. Device C can come
from any vendor.
To prevent loops, enable the spanning tree feature between the IRF fabric and Device C.
Figure 19 Network diagram
Configuration procedure
1. Configure Device A:
# Assign member ID 1 to Device A, and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] quit
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
# Save the configuration.
[Sysname] quit
<Sysname> save
# Enable IRF mode.
<Sysname> system-view
[Sysname] chassis convert mode irf
Figure 19, set up a two-chassis IRF fabric at the distribution layer of the enterprise network.
49