HP FlexFabric 12500 Series Configuration Manual page 81

******************************************************************************
<MDCB> system-view
[MDCB] interface GigabitEthernet 1/3/0/1
[MDCB-GigabitEthernet1/3/0/1] undo shutdown
[MDCB-GigabitEthernet1/3/0/1] quit
[MDCB] interface GigabitEthernet 2/5/0/1
[MDCB-GigabitEthernet2/5/0/1] undo shutdown
[MDCB-GigabitEthernet2/5/0/1] quit
# Change the device name to MDCB for easy identification of the MDC.
[IRF] sysname MDCB
# Assign an IP address to the virtual management Ethernet interface and enable the Telnet service
on the interface to allow remote management of MDC B.
[MDCB]interface M-Ethernet 1/0/0/0
[MDCB-M-Ethernet1/0/0/0]ip address 192.168.2.251 24
[MDCB-M-Ethernet1/0/0/0]quit
[MDCB]telnet server enable
[MDCB]user-interface vty 0 15
[MDCB-ui-vty0-15]authentication-mode none
[MDCB-ui-vty0-15]user-role mdc-admin
# Return to the default MDC.
[MDCB-ui-vty0-15] return
<MDCB> switchback
[IRF]
Verifying the configuration
1. Check whether the MDCs exist and are operating correctly.
<Device> display mdc
ID
----------------------------------
1
2
3
2. Telnet to MDCA and view the current configuration of the MDC.
C:\> telnet 192.168.1.251
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<MDCA> display current-configuration
#
version 7.1.034, Release 7128
#
sysname MDCA
#
telnet server enable
#
Name Status
Admin active
MDCA active
MDCB active
77
*
*
*