Rear Door Lock Assembly Removal and
Installation
Removal
1) Remove rear door glass referring to "Rear Door
Glass Removal and Installation in Section 9E".
2) Disconnect door opening control rod (1) and door
latch control rod (2).
3) Disconnect door lock motor lead wire (if equipped).
4) Loosen door latch mounting screws (3), door latch
bolt (4) and remove door latch assembly (5).
1
3
5
4
Installation
Reverse removal procedure to install rear door lock
assembly referring to the following instruction and "Front
Door Lock Assembly Removal and Installation".
• Tighten out side rear handle mounting bolt first, and
then tighten out side handle front mounting bolt.
Rear Door Lock Assembly Inspection
• Check that door opens and closes smoothly and
S3RH0A9606010
properly.
• Check that door stops in the secondary latched
position properly (preventing door from opening
freely) and that door closes completely in the fully
latched position.
• Adjust door latch striker position, if necessary.
2
I2RH01960014-01
I2RH01960015-01
Security and Locks:
9F-12
S3RH0A9606011