Centering Contact Coil - Suzuki Liana RH413 Service Manual

Installation
1) Check to make sure that vehicle's front tires are set
at straight-ahead position and then ignition switch is
at "LOCK" position.
2) Install contact coil and combination switch assembly
(3) and then connect all connectors disconnected in
Removal.
NOTE
New contact coil and combination switch
assembly is supplied with contact coil set
and held at its center position with a lock pin
(1) and seal (2). Remove this lock pin after
installing contact coil and combination
switch assembly to steering column.
3) Install steering column upper cover (2) and lower
cover (3), and then tighten steering column cover
screws (1).
CAUTION
!
When installing lower cover (3) and upper
cover (2), be careful so that contact coil and
combination switch lead wire is not caught
between covers.
2
1
4) Install steering column hole cover (1).

Centering Contact Coil

I2RH01620020-01
1
3
I2RH01620021-01
Steering Wheel and Column:
5) Install steering wheel to steering column. Refer to
"Steering Wheel Removal and Installation".
1) Check that vehicle's wheels (front tires) are set at
straight-ahead position.
2) Check that ignition switch is at "LOCK" position.
3) Turn contact coil (1) counterclockwise slowly with a
light force till contact coil (1) will not turn any further.
NOTE
Contact coil (1) can turn about four and a half
turns at the maximum. When it is at the
center position, it will turn about two and a
quarter turns both clockwise and
counterclockwise.
4) From the position where contact coil (1) became
unable to turn any further (it stopped), turn it back
clockwise about two and a quarter rotations and
align center mark (2) with alignment mark (3).
6B-6
1
I3RH0A620005-01
S3RH0A6206003
I2RH01620013-01
I2RH01620014-01