1K-2 Exhaust System:
Exhaust Manifold Components
1-1. Exhaust manifold (with oxygen sensor)
1-2. Exhaust manifold (without oxygen sensor)
2. Exhaust manifold gasket
3. Heated oxygen sensor (if equipped)
4-1. Exhaust manifold cover (with oxygen sensor)
Exhaust Manifold Removal and Installation
Removal
WARNING
!
To avoid danger of being burned, do not
service exhaust system while it is still hot.
Service should be performed after system
cools down.
1) Disconnect negative cable at battery.
2) Disconnect heated oxygen sensor coupler (1) (if
equipped) and detach it from its stay.
3) Remove exhaust manifold cover (2).
4) Remove exhaust manifold stiffener (1).
5) Remove exhaust No.1 pipe (2) from exhaust
manifold.
4-2. Exhaust manifold cover (without oxygen sensor)
5. Engine hook
6. Exhaust manifold stiffener
7. Gasket
8. Exhaust manifold mounting nut
S3RH0A1B06003
2
1
I2RH0B1B0003-01
2
6) Remove exhaust manifold (1) and its gasket from
cylinder head.
1
Installation
1) Install new gasket to cylinder head. Then install
exhaust manifold.
Tighten manifold bolts and nuts to specified torque.
S3RH0A1B06002
I3RH0A1B0002-01
9. Exhaust manifold stiffener bolt
10. Exhaust pipe bolt
11. Exhaust manifold mounting bolt
: Tightening torque
: Do not reuse.
1
I2RH0B1B0004-01
I2RH0B1B0005-01