Reduction Drive Gear, Reduction Idler Gear And Reduction Driven Gear Disassembly And Assembly - Suzuki Liana RH413 Service Manual

3C-9 Transfer:
14) Apply grease to new intermediate output oil seal lip.
"A": Grease 99000–25010
15) Drive intermediate output oil seal (1) in transfer right
case (2) by using special tool and hammer.
Special tool
(A): 09925–15410
Intermediate output oil seal installing depth
"a": 1.0 – 2.0 mm (0.04 – 0.08 in.)
"a"
Reduction Drive Gear, Reduction Idler Gear and
Reduction Driven Gear Disassembly and
Assembly
Disassembly
Drive out bearings of reduction drive gear, reduction idler
gear and reduction driven gear by using bearing puller
(1) and hydraulic press (2).
Assembly
1) Drive in reduction drive gear bearings (right and left)
2) Drive in reduction idler gear bearings (1) (right and
(A)
3) Drive in reduction driven gear bearings (3) (right and
1,"A"
2
I3RH01332052-01
S3RH0A3306005
Reduction idler gear taper
roller bearing
Reduction driven gear RH
taper roller bearing
Reduction driven gear LH
taper roller bearing
2
1
I3RH0A330006-01
CAUTION
!
• Bevel gear and pinion must be replaced as
a set when either replacement becomes
necessary.
• When replacing taper roller bearing,
replace as inner race & outer race
assembly.
to reduction drive gear by using bearing puller and
hydraulic press.
left) to reduction idler gear (2) by using special tools
and hydraulic press (5).
left) to reduction driven gear (4) by using special
tools and hydraulic press (5).
Special tool
(A): 09944–66060
(B): 09925–88210
Reduction gear taper roller bearings dimension
5
(A)
1
2
(B)
Outside Width
diameter
47 mm 15 mm
(1.85 in.) (0.59 in.)
52 mm 16.3 mm
(2.05 in.) (0.64 in.)
52 mm 19.3 mm
(2.05 in.) (0.76 in.)
5
(A)
3
4
(B)
I3RH01332023-01