4C-6 Rear Brakes:
Wheel Cylinder Inspection
Inspect wheel cylinder disassembled parts for wear,
cracks, corrosion or damage.
NOTE
Clean wheel cylinder components with brake
fluid.
Brake Back Plate Removal and Installation
Removal
1) Remove brake drum referring to "Rear Brake Drum
Removal and Installation".
2) Remove brake shoe referring to "Rear Brake Shoe
Removal and Installation".
3) Remove wheel cylinder referring to "Wheel Cylinder
Removal and Installation".
4) Remove cable from brake back plate by squeezing
parking brake cable stopper ring (1).
5) Remove wheel hub referring to "Wheel Hub with
S3RH0A4306007
Wheel Bearing and Wheel Stud Removal and
Installation (2WD Model) in Section 2C" or "Wheel
Hub, Wheel Stud / Wheel Bearing Outside Inner
Race Removal and Installation (4WD Model) in
Section 2C" and "Wheel Hub with Wheel Bearing
and Wheel Stud Removal and Installation (2WD
Model) in Section 2C".
6) Remove brake back plate (1) by removing bolts (2).
I2RH01430019-01
S3RH0A4306008
Installation
1) Apply water tight sealant to mating surfaces of brake
back plate and rear axle.
"A": Water tight sealant 99000–31090
2) Install brake back plate and tighten back plate bolts
to specified torque.
Tightening torque
Brake back plate bolt (a): 50 N·m (5.0 kgf-m, 36.5
lb-ft)
I2RH01430022-01
I2RH01430023-01
I2RH01430024-01
I2RH01430025-01