Dtc C1061 (No. 61): Abs Pump Motor And/Or Motor Relay Circuit - Suzuki Liana RH413 Service Manual

DTC C1061 (No. 61): ABS Pump Motor and/or Motor Relay Circuit

Wiring Diagram
[A]: ABS hydraulic unit / control module connector E15
1. Battery
DTC Detecting Condition
The ABS control module monitors the voltage at monitor terminal of pump motor circuit constantly with the ignition
switch turned ON. It sets this DTC when the voltage at the monitor terminal does not become high / low according to
ON/OFF commands to the motor relay (transistor) of the module (does not follow these commands).
DTC Troubleshooting
Step
1 Was "ABS Check" performed?
2 1) Check pump motor referring to "ABS Hydraulic Unit
Operation Check".
Is it in good condition?
3 1) Turn Ignition switch to OFF position.
2) Disconnect ABS hydraulic unit / control module
connector.
3) Check for proper connection to ABS hydraulic unit /
control module connector at terminal "E15-1".
4) If OK, then measure voltage between terminal "E15-1" of
module connector and body ground.
Is it 10 – 14 V?
4 Measure resistance between terminal "E15-13" and "E15-
26" of ABS hydraulic unit / control module connector and
body ground.
Is resistance less than 1
2. Main fuse box
3. Pump motor relay (transistor)
Action
Ω
?
4. ABS pump motor
5. ABS hydraulic unit / control module assembly
Yes
Go to Step 2.
Check terminals "E15-
1", "E15-13" and "E15-
26" connection. If
connections OK,
substitute a known-
good ABS hydraulic unit
/ control module
assembly and recheck.
Go to Step 4.
Substitute a known-
good ABS hydraulic unit
/ control module
assembly and recheck.
ABS: 4E-29
S3RH0A4504018
I3RH0A450020-01
No
Go to "ABS Check".
Go to Step 3.
"WHT/BLU" circuit
open.
"BLK" circuit in open or
high resistance.