Dtc C1061: Abs Pump Motor And/Or Motor Driver Circuit - Suzuki GRAND VITARA Owner's Manual

Grand vitara
Hide thumbs Also See for GRAND VITARA:
Table of Contents

Advertisement

4E-24 ABS:
Step
5
1) Measure voltage between terminals "E03-14" and "E03-
13" with engine running.
±
Is voltage 18
1.0 V or less?

DTC C1061: ABS Pump Motor and/or Motor Driver Circuit

Wiring Diagram
2
1
[A]: ABS hydraulic unit / control module connector
(viewed from terminal side)
1. Battery
DTC Detecting Condition
The ABS control module monitors the voltage at monitor terminal of pump motor circuit constantly with the ignition
switch turned ON. It sets this DTC when the voltage at the monitor terminal does not become high / low according to
ON/OFF commands to the motor driver (transistor) of the module (does not follow these commands).
DTC Troubleshooting
Step
1
Was "ABS Check" performed?
2
1) Turn Ignition switch to OFF position.
2) Disconnect ABS hydraulic unit / control module
connector.
3) Check for proper connection to ABS hydraulic unit /
control module connector at terminal "E03-1".
4) If OK, then measure voltage between terminal "E03-1" of
module connector and body ground.
Is it 10 – 14 V?
3
Measure resistance between terminal "E03-13" and "E03-
26" of ABS hydraulic unit / control module connector and
vehicle body ground.
Is resistance less than 1
Action
WHT/BLU
E03-1
BLK
E03-13
BLK
E03-26
2. Main fuse box
3. Pump motor driver (transistor)
Action
?
Poor connection of
"E03-14" and/or "E03-
13" terminals. If the
terminals are in good
condition, substitute a
known-good ABS
hydraulic unit / control
module and recheck.
5
12V
3
12V
4
M
4. ABS pump motor
5. ABS hydraulic unit / control module assembly
Go to Step 2.
Go to Step 3.
Substitute a known-
good ABS hydraulic unit
/ control module
assembly and recheck.
Yes
Check charging system
referring to "Generator
Test (Overcharged
Battery Check): in
Section 1J".
[A]
E03
14
1
15
2
16
3
17
4
18
5
19
6
20
7
21
8
22
9
23
10
24
11
25
12
26
13
Yes
Go to "ABS Check: ".
"WHT/BLU" circuit
open.
Ground circuit for ABS
hydraulic unit / control
module open or high
resistance.
No
S5JB0A4504016
I5JB0A450017-02
No

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents