Contact Coil Cable Assembly Removal And Installation - Suzuki GRAND VITARA Owner's Manual

5) Remove steering wheel (1) with special tool.
CAUTION
!
Do not hammer the end of the shaft.
Hammering it will loosen the plastic shear
pins which maintain the column length and
impair the collapsible design of the column.
Special tool
(A): 09944–36011
Installation
1) Check that vehicle's front tires are at straight-ahead
position and contact coil cable assembly is centered.
Refer to "Centering Contact Coil Cable Assembly: ".
CAUTION
!
These two conditions are prerequisite for
installation of steering wheel. If steering
wheel has been installed without these
conditions, contact coil cable assembly will
break when steering wheel is turned.
2) Install steering wheel (1) to steering shaft with 2 lugs
(2) on contact coil cable assembly fitted in two
grooves (3) in the back of steering wheel and also
aligning marks (4) on steering wheel and steering
shaft.
3) Tighten steering shaft nut to specified torque.
Tightening torque
Steering shaft nut: 33 N·m (3.3 kgf-m, 24.0 lb-ft)
1
(A)
I5JB0A620009-01
4) Connect horn connector and audio control switch
connector, if necessary.
5) Install driver air bag (inflator) module to steering
wheel. Refer to "Driver Air Bag (Inflator) Module
Removal and Installation: in Section 8B".
Contact Coil Cable Assembly Removal and
Installation
CAUTION
!
Do not turn contact coil cable assembly more
than allowable number of turns (about two
and a half turns from the center position
clockwise or counterclockwise respectively),
or coil will break.
Removal
1) Remove steering wheel from steering column. Refer
to "Steering Wheel Removal and Installation: ".
2) Remove steering column hole cover (1).
Steering Wheel and Column:
1
6B-5
I5JB0A620010-01
S5JB0A6206013
I5JB0A620011-01