Rear Wiper Removal And Installation (If Equipped) - Suzuki GRAND VITARA Owner's Manual

• For automatic stop operation
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
terminal "5" and let the motor turn.
b. Disconnect terminal "1" from battery positive
(+) terminal, and let the motor stop.
c. Connect terminals "1" and "3" with a jumper
wire, and connect terminal "4" to battery
positive (+) terminal.
Observe the motor turns once again then
stops at a specified position as shown.
7
6
2
[A]
3
1
4
5
[B]
4
3
1
5
[A]: Left-hand steering vehicle
[B]: Right-hand steering vehicle
"a": 5 mm (0.20 in.)
d. Repeat Step 1) to 3) several times and check
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
"a"
2
I5JB0A940012-01
2. Windshield wiper arms with
wiper blades
6. Ceramic line
7. Wiper blade center
Rear Wiper Removal and Installation (If
Equipped)
Removal
1) Disconnect negative (–) cable at battery.
2) Remove arm cover (1), rear wiper arm nut (2) and
rear wiper arm with blade assembly (3).
3) Remove rear end door trim referring to "Rear End
Door Lock Assembly Removal and Installation: in
Section 9F".
4) Disconnect coupler from rear wiper motor.
5) Remove rear wiper motor.
Installation
1) Install rear wiper motor (1) and tighten rear wiper
motor mounting bolts to specified torque.
Tightening torque
Rear wiper motor mounting bolt (a): 7 N·m (0.7
kgf-m, 5.0 lb-ft)
1
(a)
Wipers / Washers: 9D-8
S5JB0A9406006
3
1
2
I5JB0A940013-02
I5JB0A940014-01