Table of Contents
Advertisement
6) Install steering column hole cover (1).
7) Install steering wheel to steering column. Refer to
"Steering Wheel Removal and Installation".
Contact Coil Cable Assembly Inspection
CAUTION
!
Do not turn contact coil cable assembly more
than allowable number of turns (about two
and a half turns from the center position
clockwise or counterclockwise respectively),
or coil will break.
Check contact coil cable assembly (1) wire harness for
any signs of scorching, melting or other damage.
If it is damaged, replace.
1
I5JB0A620011-01
S6JB0A6206004
1
I5JB0A620016-01
Steering Wheel and Column:
Centering Contact Coil Cable Assembly
CAUTION
!
Removal of the steering wheel allows the
contact coil cable assembly to turn freely but
do not turn the contact coil cable assembly
more than allowable number of turns (about
two and a half turns from the center position
clockwise or counterclockwise respectively),
or coil will break.
1) Check that vehicle's wheels (front tires) are set at
straight-ahead position.
2) Check that ignition switch is at LOCK position.
3) Turn contact coil cable assembly (2)
counterclockwise slowly with a light force till contact
coil cable assembly will not turn any further.
NOTE
Contact coil cable assembly can turn about 5
turns at maximum, that is, if it is at the center
position, can turn about two and a half turns
both clockwise and counterclockwise.
4) From the position where contact coil cable assembly
(2) became unable to turn any further (it stopped),
turn it back clockwise about two and a half rotations
and align center mark with alignment mark (1).
[A]
[B]
1
[A]: Turn slowly till coil stops
[B]: Turn contact coil cable assembly back about 2 and a half turns
6B-7
S6JB0A6206005
2
2
I5JB0A620017-03
Advertisement
Chapters
Table of Contents
