Abs Warning Light Comes On Steady - Suzuki Grand Vitara 2011 Manual

ABS Warning Light Comes ON Steady

Wiring Diagram
Refer to "ABS Warning Light Does Not Come ON at Ignition Switch ON".
Circuit Description
Operation (ON/OFF) of ABS warning light is controlled by ABS (ESP®) control module through light driver module in
combination meter.
If the Antilock brake system is in good condition, ABS (ESP®) control module turns ABS warning light ON at the
ignition switch ON, keeps it ON for 2 seconds and then turns it OFF. If an abnormality in the system is detected, ABS
warning light is turned ON continuously by ABS (ESP®) control module. Also, it is turned ON continuously by light
driver module when the connector of ABS (ESP®) control module is disconnected.
Troubleshooting
Step
1 1) Perform diagnostic trouble code check.
Is there any DTC(s)?
2 Are main fuses for ABS pump motor and ABS solenoid in
good condition?
3 1) Turn ignition switch to OFF.
2) Disconnect ABS (ESP®) control module connector.
3) Check for proper connection to ABS (ESP®) control
module connector at terminals "E03-7", "E03-13" and
"E03-26" (or "E53-16", "E53-35" and "E53-47").
4) If OK then turn ignition switch to ON position and
measure voltage between terminal "E03-7" (or "E53-35")
and vehicle body ground.
Is it 10 – 14 V?
4 1) Turn ignition switch to OFF position.
2) Check for proper connection to ABS (ESP®) control
module connector at terminals "E03-1" and "E03-14" (or
"E53-1" and "E53-32").
3) If OK then turn ignition switch to ON position and
measure voltage between each terminal of "E03-1",
"E03-14" (or "E53-1", "E53-32") and vehicle body
ground.
Are they 10 – 14 V?
5 1) Turn ignition switch to OFF and measure resistance
between each terminal of "E03-13", "E03-26" (or "E-53-
16", "E53-47") and vehicle body ground.
Is resistance less than 2
6 Check CAN communication circuit between combination
meter and ABS (ESP®) control module referring to "DTC
U1073: Control Module Communication Bus Off (Petrol
Engine Model)".
Is CAN communication circuit in good condition?
Action
Ω
?
Yes
Go to applicable DTC
diag. flow.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Substitute a known-
good combination meter
and recheck. If ABS
warning light remains
ON, substitute a known-
good ABS (ESP®)
hydraulic unit / control
module assembly and
recheck.
ABS: 4E-15
S6JB0A4504009
No
Go to Step 2.
Replace fuse and check
circuit for short to
ground.
"GRN/ORN" circuit
open.
"WHT/RED" and/or
"WHT/BLU" circuit
open.
Ground circuit for ABS
(ESP®) hydraulic unit /
control module open or
high resistance.
Repair or replace.