P/S Gear Case Assembly Removal And Installation - Suzuki Grand Vitara 2011 Manual

P/S Gear Case Assembly Removal and
Installation
CAUTION
!
Never disassemble P/S gear case assembly.
Disassembling will adversely affect original
performance of P/S gear case assembly.
Removal
1) Disconnect negative (–) cable at battery.
2) Take out P/S fluid in reservoir with syringe or such.
3) Hoist vehicle and remove both right and left wheels.
4) Disconnect both right and left tie-rod ends from
knuckle referring to Step 2) to 3) of "Removal" in
"Tie-Rod End Removal and Installation".
5) (F9Q engine model)
Remove generator referring to "Generator
Dismounting and Remounting: For Diesel Engine
Model in Section 1J".
6) (F9Q engine model)
Remove P/S pump referring to "P/S Pump Removal
and Installation (F9Q Engine Model)".
7) (F9Q engine model)
Remove P/S pump bracket (1).
1
8) Disconnect steering lower shaft assembly (1) from
pinion shaft of P/S gear case assembly (2) referring
to Step 5) of "Removal" in "Steering Lower Shaft
Assembly Removal and Installation in Section 6B".
9) Disconnect high pressure pipe (3) from P/S gear
case assembly.
10) Disconnect low pressure pipe (4) from P/S gear case
assembly.
11) Remove P/S gear case cylinder pipes (5) from P/S
gear case assembly.
S6JB0A6306014
12) Remove stabilizer bar mount bolt and stabilizer joint.
NOTE
Do not remove stabilizer bar from vehicle.
13) Remove stabilizer bar mount bracket (2) from left
side of front suspension frame.
14) Remove bolts (1) and then take off P/S gear case
assembly from left side of vehicle.
NOTE
P/S gear case assembly cannot be removed
from the right side of vehicle.
I5JB0B630005-01
1
Power Assisted Steering System:
5
2
3
4
2
1
6C-14
1
I5JB0A630017-01
I5JB0A630018-01
1
I5JB0A630019-01