Air Intake Control Actuator Removal And Installation; Air Intake Control Actuator Inspection - Suzuki Grand Vitara 2011 Manual

7A-16 Heater and Ventilation:
4) Connect battery positive (+) terminal to terminal "a"
and battery positive (–) terminal to terminal "b".
Check if position of actuator lever changes HOT
position to COLD position.
If malfunction is found, replace temperature control
actuator with new one.
1
"a" "b" "c" "d" "e"
"a" "b"
A: Max cold position
B: Max hot position
C: Approx. 72°
Air Intake Control Actuator Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove glove box.
3) Disconnect air intake control actuator connector (2).
4) Remove screws and then, remove air intake control
actuator (1) from HVAC unit.
A
C
B
"c" "d" "e"
I5JB0A710017-03
S6JB0A7106017
1
2
I5JB0A710018-01
Installation
Reverse removal procedure.

Air Intake Control Actuator Inspection

1) Remove air intake control actuator (1). Refer to "Air
Intake Control Actuator Removal and Installation".
2) Check resistance between "d" and "e" terminals of
actuator.
Air intake control actuator resistance
LH steering vehicle
REC position: Approx. 4.5 kΩ
FRE position: Approx. 1.2 kΩ
RH steering vehicle
REC position: Approx. 1.2 kΩ
FRE position: Approx. 4.5 kΩ
3) Connect battery positive (+) terminal to terminal "a"
and battery negative (–) terminal to terminal "b".
Check if position of actuator lever is REC position.
4) Connect battery positive (+) terminal to terminal "b"
and battery negative (–) terminal to terminal "a".
Check if position of actuator lever is FRESH position.
[A]
C
E
D
1
"a" "b" "c" "d"
"a"
[A]: LH steering vehicle
[B]: RH steering vehicle
C: REC position
D: FRESH position
E: Approx. 60°
S6JB0A7106018
C
[B]
E
D
1
"e"
"b" "c" "d" "e"
I5JB0A710019-03