Air Bag" Warning Lamp Cannot Indicate Flashing Pattern Of Dtc (If Equipped With "Air Bag" Monitor Coupler) - Suzuki Grand Vitara 2011 Manual

8B-23 Air Bag System:
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
Flow Test Description
Step 1: Check that vehicle is equipped with or without "AIR BAG" monitor connector.
Step 2: Check "AIR BAG" monitor coupler.
Step 3, 4: Check for short circuit between diagnosis switch circuit and ground.
Troubleshooting
Step
1 Is vehicle equipped with "AIR BAG" monitor connector?
2 Check "AIR BAG" monitor coupler.
Is the diagnosis switch terminal in "AIR BAG" monitor
coupler connected to body ground with service wire?
3 1) With ignition switch OFF, disconnect SDM connector
"G47" or "G46".
2) Check "G47-14" or "G46-12" terminal of SDM connector.
Is it shorted to ground terminal or harness?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
"AIR BAG" Warning Lamp Cannot Indicate Flashing Pattern of DTC (If Equipped with "AIR BAG"
Monitor Coupler)
Wiring Diagram
Refer to ""AIR BAG" Warning Lamp Flashes".
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
Flow Test Description
Step 1: Check "AIR BAG" monitor coupler.
Step 2: Check for open circuit in air bag diagnosis switch circuit.
Action Yes
Go to Step 2.
Remove service wire.
Clean up terminal or
harness.
No
Go to Step 3.
Go to Step 3.
Substitute a known-
good SDM and recheck.
S6JB0A8204010