Chapter 3 Connection Of Programming Tools And Got - Mitsubishi Electric Q03UDVCPU User Manual

CHAPTER 3
This chapter explains how to connect the CPU module to a programming tool or GOT.
● The CPU module and programming tool can be connected directly (simple connection) through one Ethernet cable. In
direct connection, the module and the tool can communicate with each other without each other's IP address in mind.
( Page 48, CHAPTER 4)
● GOT on Ethernet can be accessed from the programming tool via the built-in Ethernet port of a CPU module.
( Page 31, Section 3.5)
To start Ethernet communication, perform the following steps.
Writing to the CPU module
Connecting cables and external devices
Setting the connection target
For the GOT setting, refer to the following manual.
Connection Manual (Mitsubishi Products) for GOT used
24
CONNECTION OF PROGRAMMING
TOOLS AND GOT
CPU module
Hub
Programming
tool
Start
Configure PLC parameters by the programming tool.
Setting parameters
(
Write the configured parameters to the CPU module.
Power it on again or reset it for the parameters to
take effect.
(
Connect cables and devices required for Ethernet
communication.
Set a connection target by the programming tool.
(
End
CPU module
Ethernet
Programming GOT
tool
Page 25, Section 3.1
Page 26, Section 3.1 (2)
Page 27, Section 3.2
)
)
)