4.1
Setting Method
Set the items on the Transfer Setup window.
Connection Destination window
2.
3.
1.
Select "Ethernet Board" for "PC side I/F".
2.
Select "PLC Module" for "PLC side I/F".
In the "PLC side IF Detailed Setting of PLC Module" window, select the Ethernet Port Direct Connection
checkbox as shown below.
3.
Complete setting of "Other Station Setting".
Select an item appropriate to the operating environment.
When performing relay communication to another network, make the following settings as well, and use
the connection destination specification of the programming tool to access another network.
(
Page 31, Section 3.5)
CHAPTER 4 DIRECT CONNECTION TO PROGRAMMING TOOL (SIMPLE CONNECTION)
[Connection1]
1.
49
4