Silvercrest SBL 3.5 A1 Operation And Safety Notes page 8

Radio interface
Switch the product off on airplanes, in hospi-
tals, service rooms, or near medical electronic
systems. The wireless signals transmitted could
impact the functionality of sensitive electron-
ics. Keep the product at least
from pacemakers or implantable cardioverter
defibrillators, as the electromagnetic radiation
may impair the functionality of pacemakers.
The radio waves transmitted could cause in-
terference in hearing aids. Do not place the
product near flammable gasses or potentially
explosives areas (e.g. paint shops) with the
wireless components on, as the radio waves
emitted can cause explosions and fire. The range
of the radio waves varies by environmental
conditions. In the event of wireless data trans-
mission, unauthorised third parties receiving
the data cannot be excluded.
not responsible for interference with radios or
televisions due to unauthorised modification
of the product. Lidl US LLC
liability for using or replacing cables and
products not distributed by
the product is fully responsible for correcting
interference caused by such unauthorised
modification of the product, as well as re-
placement of such products.
Changes or modifications to this product not
expressly approved by the party responsible
for compliance could void the user's authority
to operate the product.
Note: This product has been tested and com-
plies with the limits for a Class B digital device,
8 US-EN
286212_silv_Bluetooth-Lautsprecher_content_US.indd 8
7.874 in / 20 cm
Lidl US LLC is
further assumes no
Lidl US. The user of
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable pro-
tection against harmful interference in a resi-
dential installation. This product generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
product causes harmful interference to radio or
television reception, which can be determined
by turning the product off and on, the user is
encouraged to try and correct the interfer-
ence by one or more of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the prod-
uct and receiver.
• Connect the equipment to an outlet on a
different circuit than the one the receiver is
connected to.
• Consult the dealer or an experienced ra-
dio / TV technician for help.
This product complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This product may not cause harmful inter-
ference, and
(2) this product must accept any interference
received, including interference that may
cause undesired operation.
The RF Exposure Compliance distance is
0,20 in / 5 mm.
05.04.17 09:40