Service Walk Test; Invisible Walk Test - Bosch B6512 Installation Manual

68 en | Program and test the control panel
–
–
–
–
–
A controlled point can be programmed for trouble when disarmed.
Performing an intrusion walk test:
1.
2.
3.
4.
5.
16.2.3

Service walk test

A service walk test allows you to walk test points assigned to any point type. The area scope
of the keypad that initiates the walk test determines which points are included in the test. All
points are included when the keypad scope is panel wide, including those with a Point Index
of 0.
A service walk test includes points:
–
–
–
During a service walk test:
–
–
–
Performing a service walk test:
1.
2.
3.
4.
5.
16.2.4

Invisible walk test

An invisible walk test allows you to test both controlled points and 24-hr points. Points
assigned to Point Indexes with the Invisible Point parameter set to Yes.
An invisible walk test includes points meeting the following criteria:
–
2017.04 | 15 | F.01U.287.180
Have a point source other than Unassigned
Have a point index not set to Disabled (must be non-zero)
Point type must be for a Controlled Point; Part-On, Interior, or Interior Follower
Are not service bypassed
Are not invisible points
Choose a keypad to conduct the test. Ensure that all areas are off (disarmed).
Open Main Menu and then go to the [3] Actions Menu > [3] Test > [1] Walk Test > [1]
Intrusion.
The keypad shows the number of points that remain untested.
To view the list of points, press Enter or View untested points. To scroll through the list
of points, use /Previous or
When you fault a point (open a door for example), the keypad emits a brief tone and
shows the point name and that it has been tested (for example, Pt-4: P4 Follow Tested).
with a point source other than Unassigned
that are disabled (Point Index set to 0) in addition to those that are enabled (non-zero
Point Index)
that you have service bypassed
The summary alarm and summary fire remain off, because there are no Fire or Burg alarm
conditions to summarize.
The test does not generate any Extra Point troubles.
The test does not log any Extra Point events.
Choose a keypad to conduct the test. Ensure that all areas are off (disarmed).
Open Main Menu and then go to the [3] Actions Menu > [3] Test > [1] Walk Test > [1]
Service.
The keypad shows the number of points that remain untested.
To view the list of points, press Enter or View untested points. To scroll through the list
of points, use /Previous or
When you fault a point (move in front of a motion sensor for example), the keypad emits a
brief tone and shows the point name and information (for example, Area-1 Point-7
Onboard: Short).
Have a point source other than Unassigned
/Next.
/Next.
Installation Manual
Control Panels
Bosch Security Systems, Inc.