Diagnostic Leds - Bosch B6512 Installation Manual

Control Panels
Wire to the antenna
The module has a threaded connector for connection to an antenna. Route the antenna cable
through a wire knockout in the top of the enclosure. Connect the antenna cable to the
module. Secure the antenna cable to the outside of the enclosure.
When you wire an SDI2 module to a control panel, you can use either the terminal strip
labeled with PWR, A, B, and COM to wire to corresponding SDI2 terminals labeled on the
control panel, or you can use the interconnect wiring connector and the included interconnect
cable.
For terminal wiring, use 18 AWG to 22 AWG (1.02 mm to 0.65 mm) wire.
Notice!
Use either the terminal strip wiring or interconnect wiring to the control panel. Do not use
both. When connecting multiple modules, you can combine terminal strip and interconnect
wiring connectors in series.
3
Figure 8.5: B450 to control panel wiring - terminal strip or interconnect wiring connector (B5512 shown)
Callout ᅳ Description
1 ᅳ Control panel
2 ᅳ Module
3 ᅳTerminal strip wiring
4 ᅳ Interconnect cable
8.4.4

Diagnostic LEDs

The B450 includes the following on-board LEDs to assist with troubleshooting:
–
–
–
The plug-in module also includes LEDs for troubleshooting and status.
Flash pattern
once every 1 sec
Bosch Security Systems, Inc.
SDI2 ON-BOARD POINTS
Device Bus
1
Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
2
R
Y
G
B
Heartbeat (system status).
RX (receive).
TX (transmit).
C
OUTPUT
B
7 COM 8
6 7 COM 8
2
R
R
Y
Y
G
G
B
B
Function
Normal state. Indicates normal operation.
Flashes
Installation Manual
IP communications | en
SDI2
ON-BOARD POINTS
Device Bus
1
Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
4
2017.04 | 15 | F.01U.287.180
41
C
OUTPUT
B
7 COM 8
6 7 COM 8