42
en | IP communications
Flash pattern
3 quick flashes every 1 sec
Tab. 8.9: Heartbeat LED descriptions
Flash pattern
RX (Receive)
TX (Transmit)
Tab. 8.10: RX and TX LED descriptions
Refer to the module's Installation and Operation Guide for more information on the LEDs and
troubleshooting.
8.5
Compatible receivers for IP communication
When the control panel is configured to report in Modem4 format, the Conettix central station
receiver/gateway and the D6200 Programming/Administration Software may require an
update. Requirements are shown in the Modem4 requirements table below.
Receiver/Gateway
Conettix D6600 Communications Receiver/Gateway
(with D6641 line cards installed only)
Conettix D6100IPv6 Communications Receiver/Gateway 01.10.00
Conettix D6100i Communications Receiver/Gateway
When the control panel is configured to report in the Contact ID reporting format, the
Conettix central station receiver/gateway and the D6200 Programming/Administration
Software may require an update as shown in the Contact ID requirements table below.
ContactID reporting format requirements
Receiver/Gateway
Conettix D6600 Communications Receiver/Gateway
(with D6641 line cards installed only)
2017.04 | 15 | F.01U.287.180
On Steady
Off
Installation Manual
Function
Communication error state. Indicates a bus
communication error with the control panel.
Trouble state. Indicates a trouble condition
exists. Examine the other LEDs to determine
the trouble condition.
LED trouble state. Indicates the module is
not powered up, or there is a failure in the
module. Check for proper installation.
Function
Occurs every time a packet is received on-air.
Flashing
Occurs every time a packet is transmitted on-
air.
Flashing
CPU version
D6200 version
01.10.00
2.10
2.10
01.10.00
2.10
CPU version
D6200 version
01.03.02
1.35
Bosch Security Systems, Inc.
Control Panels