Table of Contents
Advertisement
PWM-T210
Locating the Center of the Display
CAUTION: Proper installation procedure by qualified personnel as outlined in the installation
instructions must be adhered to. Failure to do so could result in serious personal injury and
possible damage to the flat panel.
WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SURFACE TO PREVENT
DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO
WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON
THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS
HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY
RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO
COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT
PANEL.
Tape
Measure
Display
Bottom
Figure 1
1. Once the flat panel is inverted, use a
measuring tape to find the center of
your
flat
outside to outside of the chassis
(Figure 1).
Mounting Bracket Positioning
Installation Instructions
Inverted
Display
Display
Top
C L
panel
measuring
from
Display Bottom
3. Lay the left and right mounting brackets
over the mounting points, with the stamped
arrows facing out (Figure 3).
Marking the
Center of the
Display
2. Using a pencil lightly mark the
center
(Figure 2).
Left
Mounting
Bracket
Right
Mounting
Bracket
Arrows Facing
Out
Figure 3
Inverted
Display
L C
Figure 2
of
your
flat
panel
Page 5
Advertisement
Table of Contents
