Table of Contents
Advertisement
Align the
Mounting
Brackets
Figure 4
4. Match the center of viewing guide
with the center line you marked in
step 1 (Figure 4).
Securing the Mounting Brackets
The Griplates™ have M4, M5, M6 and M8 hole patterns to fit the hardware that your flat panel requires.
NOTE:
Your plasma uses M8 x 20 or M6 x 12 Phillips screws, use the M8, or M6, mounting points.
1.
Once the mounting brackets are aligned secure the Griplate™ to the flat panel (Figure 6).
NOTE:
The dimples of the top plates have to be facing up and the bottom dimples must be facing
down.
2.
Pre-install two (2) M6 x 30 (mm) Phillips pan screws to the bottom of the left and right hand side
mounting brackets.
M4 M5 M6 M8
Page 6
L C
Center of
Display
Display
Bottom
DIMPLES
FACING UP
Figure 6
Figure 5
5. The mounting brackets are designed
with a center of viewing guide on the
side of them (Figure 5).
Screwdriver
DIMPLES
FACING UP
DIMPLES
FACING DOWN
DIMPLES
FACING DOWN
PWM-T210
Display
Bottom
Mounting Bracket
Viewing
Guide
Center
Display Bottom
Installation Instructions
Advertisement
Table of Contents
