Table of Contents
Advertisement
IP-HE950 Hardware User's Guide
Be sure to turn off the power and then unplug the power cord before installing or removing an
SPF module, which is a hardware option. In addition, when connecting this unit with a
conversion cable, pay special care and attention to not damage the conversion cable.
The SFP module has a lock mechanism. Firmly insert the module until it locks. When removing
the module, hold down the unlock mechanism. Never forcibly remove the module because that
may cause damage.
For instructions on configuring and using the SFP module, refer to the IP-HE950 Software
User's Guide.
- Removing SFP module
When removing the SFP module, press the unlock mechanism in the direction indicated
by the red arrow shown in the following figure with the Quad 3G-SDI conversion cable left
connected. Keep holding down the unlock mechanism as you pull the SFP module
straight out of the unit.
(1) Unlock the lock.
(2) Pull the SFP module straight out of the unit.
Figure 2-13 Removing an SFP module
34
Chapter 2 Installation and Connection
Copyright 2017 FUJITSU LIMITED
Advertisement
Table of Contents
