ABB SM2000 User Manual page 13

...2.4 Bargraph Views (Horizontal and Vertical)
Configuration
Setup
Operator Messages
1 - 6 Start of batch
7 - 12 End of batch
13 - 18 Standby mode active
19 - 24 Cleaning in progress
<user defined> No message
No message
Max/Min Reset
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
All
Alarm Acknowledge
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
All
AutoView Scroll
Select the Configuration level – See Section 4.
Select the Set Up level – see Section 3.
Add one of 24 predefined Operator Messages (see Section 4.4.5) or one User Defined
Message to the alarm event log. If User Defined is selected, a data entry keyboard appears
to enable the message to be entered – see Fig. 4.5. The selected or user defined message
is displayed on-screen briefly.
Reset the Maximum and Minimum value markers on one or all channels to the current
value.
Notes.
• These Maximum and Minimum values are for display purposes only. They are not saved
or archived and are not connected to the Totalizer Maximum and Minimum Values
displayed in the Process View.
• These Maximum and Minimum values are reset whenever the current configuration has
been changed or is re-saved.
Acknowledge active alarms in the current process group either individually or globally.
Note. Active alarms are identified by a flashing red 'Alarm Status' icon in the bottom left
hand corner of the associated channel indicator and a Global Alarm icon in the title bar –
see Fig. 2.4. If the Global Alarm icon is surrounded by a flashing red border, an active alarm
is unacknowledged.
If neither alarm on a particular channel is configured, the short channel tag appears
greyed-out in the menu.
Select AutoView Scroll to display the chart for each configured process group in turn for 40
seconds. The AutoView Scroll icon (
screen when AutoView Scroll is active. Press any key to cancel AutoView Scroll.
2 OPERATION...
) is displayed in the status bar at the top of the
11