Process Group Configuration; Setting The Recording Parameters - ABB SM2000 User Manual

4.5 Process Group Configuration

System Configuration
Common Process
Configuration Group 1
Group 2 I/O
Channels Modules
Note. If only one Process Group has been selected in the common configuration set up, only one
Process Group icon is displayed in the main configuration window.

4.5.1 Setting the Recording Parameters

N
ote. Parameters marked
Recording
Chart Bar Process
Tag 20 Characters
Recording enable source None
Process Group 1
Group 1 Process
Channels Group 2
Functions
Process Group 2
Fig. 4.8 Selecting Process Group Configuration
B
are displayed only if Basic Configuration is selected – see Table 4.1 and Section 4.4.1.
Digital Archive
Group 1 Configuration
Recording
Chart
or
Primary sample rate HH:MM:SS:ms
Secondary sample rate HH:MM:SS:ms
Sample rate source None
Enter the Process Group tag that appears in the title bar
when any operator views from that group are displayed.
Set the edge-triggered digital source (e.g. Alarm Signal,
B
Real-time Event) used to enable/disable recording of all
channels in the group.
Enabled
4 CONFIGURATION...
Bar Process Digital Archive
Tag 20 Characters
Recording On, Off
Disabled
49