Videographic Recorder
SM1000
4.5 Process Group Configuration
Fig. 4.9 Selecting Process Group Configuration
Note. If 'Number of groups' is set to '1' (see Section 4.4.1, page 52), only one Process Group and its associated channels is
displayed in the configuration menu.
4.5.1 Setting the Recording Parameters
IM/SM1000 Issue 11
Process Group 1
or
Process Group 2
(see Note below)
Enter the process group tag (maximum 20 characters) that
appears in the title bar when any operator views from that group
are displayed.
Note. Each process group tag
Select a signal source to enable/disable recording of all
channels in the current Process Group. Refer to Appendix A,
page 104 for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) enables recording. A falling edge (active to inactive)
disables recording.
Enabled
4 Configuration
be unique.
must
Disabled
61