Process Group Configuration; Setting The Recording Parameters - ABB SM1000 User Manual

4.5 Process Group Configuration

Common
Group 1
Channels 1.1 - 1.6
Group 2
Channels 2.1 - 2.6
Functions
I/O Modules
Exit
Note. If only one Process Group has been selected in the common configuration setup
(see Section 4.4.1), only one Process Group is displayed in the configuration menu.

4.5.1 Setting the Recording Parameters

Recording
Chart Bar Process
Tag 20 Characters
Recording enable source None
Process Group 1
or
Process Group 2
(see Note below)
Fig. 4.9 Selecting Process Group Configuration
Digital Archive
Group Configuration
Recording Chart Bar Process
20 Characters
Tag
On, Off
Recording enable source
Primary sample rate MM:SS
MM:SS
Secondary sample rate
Sample rate select source None
Enter the process group tag (maximum 20 characters) that
appears in the title bar when any operator views from that
group are displayed.
Select a signal source to enable/disable recording of all
channels in the current Process Group. Refer to APPENDIX 1
for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) enables recording. A falling edge (active to inactive)
disables recording.
Enabled
Disabled
4 CONFIGURATION...
Digital Archive
49