Rs485 Modules; Ethernet Modules - ABB SM1000 User Manual

...4 CONFIGURATION
...4.7.3 Hybrid Modules
Analog i/p A1
Analog output C1 source
0.0-100.0, 4.0-20.0mA
Analog output C1 range
Analog Output C1 Range
Engineering low
Engineering high
Electrical low
Electrical high
None
Analog output C2 source
Off
Analog output C2 range

4.7.4 RS485 Modules

Refer to APPENDIX 2 for information on using the Modbus link.
A:- Analog i/p C:- RS485
Modbus
Protocol
Four wire
Type
19200
Baud rate
Odd
Parity
99
Address

4.7.5 Ethernet Modules

Refer to the Ethernet Communications Option User Guide Supplement (IM/SMENET) for information on how to install, configure and
use the instrument on an Ethernet network and for information on configuring and using the e-mail facility.
A:- Analog i/p C:- Ethernet
IP-address 192.168.1.1
76
0.0
100.0
4.0 mA
20 mA
email 1 email 2
Select the analog output source.
Note. The analog output source can be any internal or
external analog signal.
Set the required analog output engineering and electrical
ranges.
Note. The 'Engineering low' and 'Engineering high' settings
are the engineering values corresponding to the 'Electrical
low' and 'Electrical high' values below.
The 'Electrical low' and 'Electrical high' values are the
minimum and maximum values of the current output, in
Electrical units – range 0 to 21mA.
Source Range H igh
Analog Output
Engineering High
Analog Output
Engineering Low
Source Range Low
Select according to the number of transmission wires
connected to the instrument: 4-wire, 2-wire.
Select the Baud rate used by the host system: 1200, 2400,
4800, 9600, 19200, 38400, 115200.
Select the Parity used by the host system: None, Odd, Even.
Set a unique Modbus Address that allows the host system to
identify the instrument on a Modbus link.
Note. Maximum 31 slaves per loop.
21mA
Analog Output
Electrical High
Analog Output
Electrical Low
0mA