Security - ABB SM1000 User Manual

4.4.3 Security

Note. User 1 is the System Administrator and is able to change the user names, passwords and access privileges of all other
users. Other users can change their own user name and password only.
User 2
Name Operator 2
Password ****
Access Enabled
Set the user name(s) and associated password(s) that will be
used to access the Configuration level when 'Configuration
security' is set to 'Password protected' – see below.
Enter a name for the selected user.
Enter an initial password for the selected user.
Set access privileges for the selected user.
Enabled – The selected user is able to access the
Configuration level.
No access – The selected user is unable to access to
the Configuration level.
Note. When the method of access to the Configuration level
is set to 'Password protected' (see below) and a user with
Configuration level access
instrument's configuration, the 'Name' of the user is
included in the audit log entry.
Set the method of access to the Configuration level. If
'Password protected' is selected, access is by means of the
password set above.
Note. If 'Switch protected' is selected, access to the
Configuration level for all users is prohibited once the
changes have been saved and made active. Access to the
Configuration level is then achieved only by setting the
internal security switch to the 'Configuration Level Not
Protected' position – see Fig. 4.2, page 39.
When set to 'On', access to the Setup level is protected by a
single password for all users.
Enter the password to be used by all users to access the
Setup level.
Note. Displayed only when 'Setup level security' is set to
'On' – see above.
4 CONFIGURATION...
privileges changes the
47