Panasonic KX-TDA100 Installation Manual page 181

3.3 Installation of the KX-TDA Maintenance Console
1. Click "Start" "Programs"
"KX-TDA Maintenance Console"
"KX-TDA Maintenance Console".
2. Type the Installer Level Programmer Code
(default: 1234), then click [OK].
The Programmer Code authorises different
programming levels, and the Quick Setup is
only available when you start the KX-TDA
Maintenance Console with Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes
with limited authorisation: Administrator
Level (default: 1111), and User Level
(default: none).
3. Click "Connect"
Note
To connect with USB, you need to have
installed the KX-TDA USB driver. Follow
the instructions of the wizard to install the
KX-TDA USB driver.
4. Type the system password for installer
(default: 1234), then click [OK] to log-in.
5. When country/area data do not match:
a.
Click [OK] to replace the country/area
data of the Hybrid IP-PBX. Replacement
may take several minutes to complete.
b.
Follow the procedure described in
"2.13.1 Starting the Hybrid IP-PBX" and
restart the Hybrid IP-PBX.
c.
Repeat steps 1 to 3 to restart the KX-
TDA Maintenance Console.
"USB" from the menu bar.
Installation Manual 181