Installing The Device - Siemens RUGGEDCOM RX5000 Installation Manual

RUGGEDCOM RX5000
Installation Guide

Installing the Device

The following sections describe how to install the device, including mounting the device, connecting power, and
connecting the device to the network.
DANGER!
Electrocution hazard – risk of serious personal injury and/or damage to equipment. Before performing
any maintenance tasks, make sure all power to the device has been disconnected and wait
approximately two minutes for any remaining energy to dissipate.
WARNING!
Burn hazard – risk of serious personal injury. Avoid contact with the surface of the unit. The metal
surface may be hot due to the high allowable ambient temperature per specification.
Éviter tout contact avec la surface. La surface métallique peut être chaude a cause d'une température
ambiante élevée selon les spécifications. S.V.P. se référer à la version française de ce guide pour les
détails.
WARNING!
Radiation hazard – risk of serious personal injury. This product contains a laser system and is
classified as a CLASS 1 LASER PRODUCT. Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
IMPORTANT!
This product contains no user-serviceable parts. Attempted service by unauthorized personnel shall
render all warranties null and void.
Changes or modifications not expressly approved by Siemens AG could invalidate specifications, test
results, and agency approvals, and void the user's authority to operate the equipment.
IMPORTANT!
This product should be installed in a restricted access location where access can only be gained by
authorized personnel who have been informed of the restrictions and any precautions that must be
taken. Access must only be possible through the use of a tool, lock and key, or other means of security,
and controlled by the authority responsible for the location.
• Section 2.1, "Mounting the Device"
• Section 2.2, "Connecting Power"
• Section 2.3, "Grounding the Device"
• Section 2.4, "Connecting the Failsafe Relay"
• Section 2.5, "Connecting to the Device"
• Section 2.6, "Cabling Recommendations"
Chapter 2
Installing the Device
5