Fiber Optic Ethernet Ports - Siemens RUGGEDCOM RX5000 Installation Manual

Chapter 3
Communication Ports
RJ45 receptacles at either end. Ground loops can cause excessive noise and interference, but more
importantly, create a potential shock hazard that can result in serious injury.
Each port features a Speed and Link LED that indicates the state of the port.
LED
Speed
Link
The following are the pin-out descriptions for the RJ45 connectors:
8
Figure 19: RJ45 Ethernet Port Pin Configuration
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.4

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
22
State
Yellow
Off
Yellow (Solid)
Yellow (Blinking)
Off
Pin
1
1
2
3
4
5
6
7
8
Description
The port is operating at maximum speed
(100 or 1000 Mbps)
The port is not operating at maximum speed
Link established
Link activity
No link detected
Name
10/100Base-TX 1000Base-TX
RX+ BI_DB+
RX- BI_DB-
TX+ BI_DA+
Reserved (Do Not Connect)
Reserved (Do Not Connect)
TX- BI_DA-
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Section 4.3, "Copper Ethernet Port
RUGGEDCOM RX5000
Installation Guide
Description
Receive Data+
or Bi-Directional
Receive Data-
or Bi-Directional
Transmit Data+
or Bi-Directional
Transmit Data-
or Bi-Directional
Fiber Optic Ethernet Ports