Irf-Port-Configuration Active - HP 12500 series Command Reference Manual

mdc-admin
Parameters
port-number: Specifies an IRF port number, which must be 1 or 2.
Usage guidelines
To set up an IRF link between two devices, you must enter IRF port view to bind physical ports to
the IRF port used by each device for IRF connection.
Before removing all port bindings on an IRF port, shut down all its physical ports.
Examples
# In standalone mode, enter IRF-port 1 view.
<Sysname> system-view
[Sysname] irf-port 1
[Sysname-irf-port1]
Related commands
port group interface

irf-port-configuration active

Use irf-port-configuration active to activate IRF port settings.
Syntax
irf-port-configuration active
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
After connecting the physical ports between two devices and binding them to the correct IRF ports,
you must manually activate the settings on the IRF ports to merge the two devices into one IRF
fabric.
You do not need to activate the IRF port settings if the configuration file that the device starts with
has included IRF port bindings or you are binding more physical ports to an IRF port after an IRF
fabric is formed. The system automatically does the work.
Examples
To configure and activate IRF port 1/2:
# Create IRF port 1/2, and bind Ten-GigabitEthernet 3/1/0/27 to it.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 3/1/0/27
[Sysname-Ten-GigabitEthernet3/1/0/27] shutdown
[Sysname-Ten-GigabitEthernet3/1/0/27] quit
[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface ten-gigabitethernet 3/1/0/27
22