Preparation; Wi-Fi Input Setup; Using A Mobile Device For Wi-Fi Setup - Hitachi AllPlay Adaptor User Manual

※Preparation

playing music, connect speakers with 3.5mm line through the AUX
hole.
Wi‐Fi input setup
You can stream music to your speaker from a mobile device on your
Wi‐Fi network by using the "Hitachi Wi‐Fi Speaker" app. To use this
feature, the speaker must join the same network as the mobile device.
Chose a network setup option from below:
1) Using a mobile device for setup. (See page)
You can set up this speaker's Wi‐Fi setting by using a mobile device
such as a smartphone or tablet.
2) Using WPS (Wi-Fi Protected Setup) (See page)
If your wireless router supports WPS, you can set up the speaker's Wi‐Fi
connection by pressing the WPS button.
1. Using a mobile device for Wi‐Fi setup
Note:
Make sure that DHCP is enabled for the network settings
on your Wi‐ Fi router.
1.
Turn the speaker on and wait for it to completely boot up. It will take
approximately 60 seconds, and during this time the Wi‐Fi LED will blink
RED and WHITE. When boot up is complete the Wi‐Fi LED will blink
WHITE.
Note : If the Adaptor has been previously setup with another network
or if you wish to re‐setup the Adaptor, you will have to set the Adaptor
to Wi‐Fi setup mode (Access Point Mode). To set the Adaptor to AP
Mode press the "WPS" button once on the Adaptor, the Wi‐Fi LED will
then blink RED indicating that the unit is ready for setup.
1. Go to the Wi‐Fi settings on the mobile device.
2. Select "HITACHI AP Adaptor XXXXX XX_XX" on mobile devices.
Note: "X" will be digits that are unique to each Adaptor.
4. Start the Internet browser on the mobile device to display the setup
page.
Note: IOS ‐ The setup page will automatically be displayed.
Android OS ‐ After you open the Internet browser, the setup
HITACHI Allplay Adaptor User`s Guide
: Before you use your AllPlay Adaptor to
6