Using Wps (Wi-Fi Protected Setup) - Hitachi AllPlay Adaptor User Manual

page will be displayed. If the setup page is not displayed, type
"http://172.19.42.1/" into the URL address field.
5. Enter a device name of your choice (e.g., Bedroom) and then select
"Next".
Note: The device name will be displayed as this speaker's name on
the network.
6. Select your "Network Name" (SSID) and type the router's Wi‐Fi pass‐
word.
Note: Check your wireless router for the network name (SSID) and
the password.
: A list of network names (SSIDs) will appear when you select
the "Network Name" box.
: To display the characters typed in the "Password" box,
select "Show Password".
: If your network requires specific settings, disable "DHCP".
You can then specify the IP Address, Subnet mask, Default
gateway, Primary DNS, and Secondary DNS.
7. Select "Connect" to apply the settings.
Note: When the connection is established, the Wi‐Fi LED on the
Allplay Adaptor will turn to a solid WHITE color.
: Depending on the mobile device, the connection complete
screen may not be displayed.
8. Make sure that your mobile device reconnects to the same network
that was used during the Allplay Adaptor setup.
Note: If the network indicator does not light up, check the network
name (SSID) and the password, and then tries the setup again.
2. Using WPS (Wi‐Fi Protected Setup)
Wi‐Fi protected setup (WPS) is a network security standard that allows
you to easily connect your Wi‐Fi Adaptor to your network.
Note:
This setup process is for Wi‐Fi routers that have the WPS
feature. Ensure that your router has this capability before
using this setup option.
1. Turn the Allplay Adaptor on and wait for it to completely boot up.
It will take approximately 60 seconds, and during this time the Wi‐Fi
LED will blink RED and WHITE. When boot up is complete the Wi‐Fi
LED will blink WHITE.
Note:
1. if the Allplay Adaptor has been previously setup with
HITACHI Allplay Adaptor User`s Guide
7