Operation Icons Of The Communication Camera Screen - Panasonic KX-HDV430 Operating Instructions Manual

3.11.2 Operation Icons of the Communication Camera Screen

Note
•
Transfer destination's operation screen (KX-HDV430)
–
When a voice call is transferred, the voice call screen is shown.
–
When a video call is transferred and the Communication Camera is registered at the transfer
destination, the video monitor screen is shown.
screen is shown.
To make a voice call while monitoring a video feed, tap the screen, and then tap
*1
Conference Calls when Connected to a Communication Camera
A video conference call cannot be established with a Communication Camera. If a third party is added
during a call with a Communication Camera, a voice conference call will be established.
3.11.2 Operation Icons of the Communication Camera Screen
Normally, the video feed is displayed in full screen. If you tap the screen, the status bar and operation area
are displayed. After a certain amount of time, the display returns to full screen. (Tap the screen again to
show the status bar and operation area.)
[While displaying the video feed from a Communication Camera (operation screen)]
Tap the screen to display the icons before performing the following operations.
•
To pan, tap or
•
To tilt, tap or
•
To zoom in, tap
•
To zoom out, tap
•
To unlock, tap
•
To switch from monitoring the video feed to a call, tap
•
To disconnect, tap
Controlling devices connected to a Communication Camera (for example, unlocking a door).
*1
90 Operating Instructions
.
.
.
.
.
*1
.
If the camera is not registered, the video call
*1
or go off-hook.
.
Document Version: 2017-08