Dimensions - ABB SACE Emax 2 Installation, Operation And Maintenance Instructions For The Installer And The User

Dimensions Information on the overall dimensions is available on the web site:
29 | © 2017 ABB | 1SDH000999R0002 - ECN000058721 - Rev. B
Continued from the previous page
IMPORTANT: Before proceeding with the connection between terminals and connection
busbars:
• make sure that the contact surfaces of the busbars are free of burrs, dents, traces of
rusting, dust or traces of grease.
• make sure, if aluminium busbars are used, than these are tin plated in the contact
areas.
• make sure that the busbars do not exert forces in any direction on the terminal.
• for tightening use M10 screws with resistance class 8.8 equipped with spring washers
and lock them with a torque of 45 Nm - 400 lb in.
NOTE: the information on the performance of the circuit-breakers in the switchgear in the
various configurations is available on the web site:
http://new.abb.com/low-voltage/products/circuit-breakers/emax2.
http://www.abb.com/abblibrary/DownloadCenter/.
The following drawings are also available in .dxf format:
• 1SDH000999R0101 - E1.2 III-IV Fixed F EF IEC-UL
• - E1.2 III-IV Fixed FC IEC-UL
1SDH000999R0102
• 1SDH000999R0103 - E1.2 III-IV Withdrawable EF IEC-UL
• 1SDH000999R0104 - E1.2 III-IV Withdrawable ES IEC-UL
• 1SDH000999R0105 - E1.2 III-IV Withdrawable SHR IEC
• - E1.2 III-IV Withdrawable FC IEC
1SDH000999R0106
• 1SDH000999R0107 - E1.2 III-IV Fixed HR-VR Positionable IEC
• 1SDH000999R0108 - E1.2 III-IV Fixed ES IEC-UL
• - E1.2 III-IV Withdrawable HR-VR IEC
1SDH000999R0109
• 1SDH000999R0120 - E1.2 Flange Fixed Withdrawable IEC-UL
• 1SDH000999R0121 - E1.2 Floor mounting IEC-UL
• 1SDH000999R0303 - E1.2 III-IV Withdrawable Rear Terminals HR-VR UL
• - E1.2 III-IV Fixed Rear Terminals HR-VR UL
1SDH000999R0307
ABB | SACE Emax 2
Emax E1.2 circuit-breakers | 6 - Installation