Installation - Panasonic KX-HNK101 Operating Instructions Manual

Setup

Installation

To mount the keypad flat against the
wall, use the mounting bracket.
Note:
R Mount the keypad on the stable
location where the keypad can be
adequately supported when
mounting.
R Do not mount keypad on a soft
material. It may fall down, break or
cause injury.
R Do not mount the keypad on the
following places: gypsum board,
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm (1 inch) thick, etc.
R Use only the supplied Panasonic AC
adaptor PNLV226KZ.
1
Remove the mounting bracket by
pressing the bracket (A) and
sliding it down (B).
A
B
2
Attach the bracket to the wall
securely using the screws (
R Place the bracket with "UP"
mark facing upwards.
10 For assistance, please visit www.panasonic.com/support
R 60 mm (2 3/8 inches)
2
1
1
3
Attach the keypad to the bracket.
R Insert the grooves on the
keypad to the 4 tabs on the
bracket, and then push down
the keypad.
4
Connect the AC adaptor plug to
the unit until you hear a click (A)
5
Connect the AC adaptor to the
power outlet (B).
)
1
2
2
1