Table of Contents
Advertisement
Installation
To mount the keypad flat against the wall, use the mounting bracket.
Note:
R Mount the keypad on the stable location where the keypad can be adequately
supported when mounting.
R Do not mount keypad on a soft material. It may fall down, break, or cause injury.
R Do not mount the keypad on a plywood surface that is less than 25.4 mm thick.
R The pull-out strength of the installation area must be at least 29.4 N (3 kgf).
Determining the installation location
Note:
R Make sure there is at least 20 cm of space to the left of the keypad (when
mounted) so that the buttons on the side of the keypad can be accessed.
1
Remove the mounting bracket.
R Place the keypad face-down on a flat surface, slide the bracket toward the
bottom of the keypad (A) by pushing it with your thumbs as shown (B),
and then lift the bracket up and away from the keypad (C).
A
B
C
Setup
11
Advertisement
Table of Contents
