Led Indicator; Setup Overview; Registering The Keypad - Panasonic KX-HNK101FX Operating Instructions Manual

LED indicator

You can use the LED indicator to
confirm the keypad's status.
Indicator Status
Off Normal operation, or
no power
Red, Keypad is not
blinking registered to a hub.
slowly
Red, Keypad is out of range
blinking of the hub.
Red, Alarm system was
blinking triggered.
quickly
Green, Registration mode
blinking (You pressed and held
slowly M

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the keypad was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
4
Installation
Install the keypad in the desired
location.
N)
Registering the
keypad
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the keypad, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Note:
R Before registering the keypad, make
sure the AC adaptors of the hub and
keypad are connected and each
device is powered.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
Keypad:
Press and hold M
LED indicator starts blinking slowly
in green and the touchpanel
buttons start blinking slowly.
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel without registering the
keypad, press M
and on the keypad again.
R If registration fails, the hub sounds
several short beeps.
Setup
OTHER
N until the
N on the hub
9