Dell 2350 User Manual page 59

•
PPTP
Cable Modem Settings
No additional settings are required. Make sure that the settings listed are correct.
DSL Static IP Settings
In the fields provided, type the IP address, IP subnet mask, ISP gateway address, and Domain
Name Server (DNS) IP address provided by your ISP.
DSL PPPoE Settings
Point to Point Protocol over Ethernet (PPPoE) is a proposal specifying how a host
computer interacts with a broadband modem (for example, DSL, cable, or wireless) to access
the network. In many respects PPPoE is similar to the Dialup Networking approach. If you
have a DSL (PPPoE) Internet connection, enter the PPPoE user name and password provided
by your ISP.
PPTP Settings
The following settings should be provided to you by your ISP.
•
IP Address
•
Subnet Mask
•
Server IP Address
•
User Name
•
Password
If your ISP specifies that you use PPTP (Point-to-Point Tunneling Protocol) as your connection
to the Internet, you cannot use the provided Setup Wizard to automatically set up your router.
Follow the instructions below to set up your connection manually:
1. Remove the Ethernet cable from the back of the computer you currently connect with,
and connect it to the Internet port of your Wireless 2350.
2. Connect the Ethernet cable provided to any of the four LAN ports, and the other end to
your computer.
3. Configure your computer's Ethernet adapter to obtain an address automatically.
4. See Windows Help for information on how to configure your computers network
adapter.