Plugging In And Ironing - Silvercrest SDBE 2600 A1 Operating Instructions Manual

Plugging in and ironing

Dry ironing without steam is possible at all tempera-
tures, steam ironing is only possible from the setting
range on the temperature control
■ Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
( symbol), the clothing item may not be
ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
■ Check the care instructions on the labels in
garments to see if they are suitable for being
ironed, and at which temperature setting.
Temperature
control
icon
■ Select the appropriate temperature setting using
the temperature control
NOTE
While it is heating up, always place the iron on
the base .
If you place the iron down on its sole
not move it, the automatic switch-off will be acti-
vated after 30 seconds (see chapter "Automatic
switch-off") and the appliance stops heating.
SDBE 2600 A1
.
Type of Material
Acrylic, rayon
Silk, wool,
polyester mix fabrics
Cotton, linen,
viscose
.
and do
The temperature control lamp
the control lamp goes out, the set temperature
has been reached.
■ Wait until the temperature control lamp
goes out.
■ To moisten the laundry, press the spray
button .
This function is suitable for very dry and very
crumpled garments.
Steam ironing
■ Set the steam control
setting.
■ The temperature control
least the setting
be produced.
Ironing with steam blast
The steam blast function is especially suitable for
smoothing difficult-to-reach parts of a garment.
■ Raise the steam iron slightly.
■ For a steam blast, press the steam blast
button .
You can also use the steam blast function to smooth
hanging textiles.
Hold the iron vertically and press the
steam blast button
Putting the steam iron down
RISK OF FIRE!
► Never leave a hot steam iron unattended if
it is switched on or connected to the mains
power supply.
lights up. When
to the desired steam
must be set to at
. Otherwise no steam can
.
GB │ IE │ NI │ 7 ■