Table of Contents
Advertisement
In Idle or during call screening: Base speaker volume levels 1 to 8 are available. (Level 1
means speaker volume off)
SKIP BACKWARD
Press twice to playback the previous message; or repeats playing the current message
9
from its beginning if this key is pressed after 4s, which counting from the beginning of
date/time stamp; or plays the previous message (if any) from its beginning if this key is
pressed within 4s, which counting from beginning of date/time stamp.
ANNOUNCE
In Idle: Short press to play the current announcement.
10
Press and hold to start recording the personalized announcement of the current answer
mode after hearing a long beep. Release key to stop recording.
ANSWER ON/OFF/ ANNOUNCE MODE
11
Toggle among: Switch the answering machine on/off, Announce Only and Announce &
Record Mode
12
CHARGING CRADLE
BLUETOOTH KEYS
In Idle, to pair up Bluetooth cellular: Press any one for 2s to initiate cellular pairing mode,
the 7-seg LED will display and flash "C x" to initiate cellular pairing mode. X can be 1 or 2
13
and it depends on which key user pressed.
In idle, to pair up Bluetooth headset: Press and hold for more than 5 sec, the 7-seg LED will
display and flash "H" to initiate headset pairing mode.
FIND
14
Press to find/page all registered handsets.
Message counter display
2-digit 7-seg
Behavior
LED display
0
No messages.
0 (flashing)
The clock needs to be set.
Total number of old messages and memos, or message number currently
1-99
playing.
Total number of messages and memos. The number flashes when there are new
1-99
messages.
(flashing)
After a power failure, the number in the message counter will flash to indicate the
clock needs to be set.
10-99
Current remote access code while setting.
1-99
Elapsed time while recording a memo or announcement up to 90 seconds.
(counting)
99 (flashing)
A memo recording is longer than 99 seconds.
1-99 & F
Memory is full. Messages must be deleted before new message can be
(alternating)
recorded.
The system is answering a call, being accessed remotely, or the clock is being
--
set.
-- (flashing)
The system is being setup, initialized or messages are being deleted.
02, 04, 06, tS
Displayed while setting the number of rings.
1-8
Displayed for 2 seconds while adjusting the volume of base speaker.
HI, LO, OF
Displayed for 2 seconds while adjusting the volume of base ringer.
Paging
Paging is useful if you misplace your handset(s).
To start the paging tone:
• Press FIND on the base. This starts the paging tone on the handset(s) for 60 seconds.
Advertisement
Table of Contents
