Motorola B801 User Manual page 21

To resume a CELLULAR call that is on hold:
• Press the CELLULAR again.
3.3.20 Temporary ringer silencing
Press OFF/BACK or DELETE/MUTE while the telephone is ringing to silence the ringer
temporarily. This will silence the ringer without disconnecting the call. The next incoming call will
ring normally at the preset volume.
NOTE
Each handset will ring when there is an incoming call unless the ringer volume is turned off.
Pressing
OFF/BACK or DELETE/MUTE on one handset will only silence the ringer of that particular
handset.
3.3.21 Chain dialing
This feature allows you to initiate a dialing sequence from numbers stored in the directory, caller
ID history or redial list while you are on a call. This feature is available only when you are making
a HOME call.
Chain dialing can be useful if you wish to access numbers other than phone numbers (such as
bank account information or access codes) from the directory, caller ID history or redial list.
Directory
1. Press MENU/SELECT twice.
2. Press DIR / CID to scroll to the desired number.
3. Press MENU/SELECT to dial the displayed number.
Caller ID history (call log)
1. Press MENU/SELECT.
2. Press DIR / CID to scroll to >CALL LOG.
3. Press MENU/SELECT.
4. Press DIR / CID to scroll to the desired number.
5. Press MENU/SELECT to dial the displayed number.
Last number redial (redial list)
Press REDIAL/PAUSE to display and dial the most recently dialed number. If you press
REDIAL/PAUSE again within two seconds, the number will not be dialed.
NOTES
1. You cannot edit a directory entry while you are on a call.
2. You cannot copy a caller ID entry into the directory while you are on a call.
3. While on a call, only the most recently called number can be reviewed, and erasing the entry is
not allowed.
4. Press OFF/BACK to exit redial, directory or caller ID history when you are on a call.
3.4 Intercom
Use the intercom feature for conversations between handsets.
You can buy additional expansion handsets for this telephone base. Up to 6 handsets can be
registered to the telephone base.
The first nine handsets that you register will be named Handset 1-6. Use the handset number to
intercom and transfer calls.
3.4.1 Call another handset
1. Press MENU/SELECT when in idle mode to enter the feature menu.
2. Use DIR / CID to scroll to >INTERCOM, then press MENU/SELECT.