Table of Contents
Advertisement
System announces "Time and day not set."
• You need to reset the answering system date and time. Refer to Section 6.1 Set Date and
Time for details.
System does not respond to remote commands
• Make sure to enter your remote access code correctly.
• Make sure you are calling from a touch-tone phone. When you dial a number, you should hear
tones. If you hear clicks, the phone is not a touch-tone telephone and cannot activate the
answering system.
• The answering system may not detect the remote access code while your announcement is
playing. Try waiting until the announcement is over before entering the code.
• There may be interference on the phone line you are using. Press the dial pad keys firmly.
System does not record message
• Make sure the answering system is on.
• Make sure the memory of the answering system is not full. Delete some messages to free
space if memory is full.
Outgoing announcement is not clear
• When you record your announcement, make sure you speak in a normal tone of voice, about
nine inches from the telephone base.
• Make sure there is no background noise (TV, music, etc.) while recording.
Advertisement
Table of Contents
