Siemens SINUMERIK 840D sl Operating Manual page 128

Machining the workpiece
5.10 Editing a program
Opening and closing blocks
Remove block
Note
You can also open and close blocks with the mouse or using the cursor keys:
• <Cursor right> opens the block where the cursor is positioned
• <Cursor left> closes the block if the cursor is positioned at the beginning or end of the
block
• <ALT> and <Cursor left> closes the block if the cursor is located within the block
128
6. Press the ">>" and "View" softkeys.
7. Press the "Open blocks" softkey if you wish to display the program with
all blocks.
8. Press the "Close blocks" softkey, if you wish to display the program
again in a structured form.
9. Open the block.
10. Position the cursor at the end of the block.
11. Press the "Remove block" softkey.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal