Siemens SINUMERIK 840D sl Operating Manual page 228

Tool management
10.5 Tool list
Unloading tool on code carrier
According to the corresponding setting, the unloaded tool on the code carrier is deleted from
the NC memory after reading out the code carrier.
Deleting tool on code carrier
The deletion of the tool can be set differently, i.e. the "On code carrier" softkey is not
available.
References
A description of the configuration options can be found in the following reference:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
228
1. The tool list is opened.
2. Place the cursor on the tool that you would like to unload from the mag-
azine and press the "Unload" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code
carrier.
1. The tool list is opened.
2. Position the cursor on the tool on the code carrier that you want to de-
lete.
3. Press the "Delete tool" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code
carrier. The tool is then deleted from the NC memory.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal