Assembling Your Metro - Pioneer Metro Installation & Owner's Operation Manual

Assembling your Metro wood fi re
Diagram 2 - Firebox brick and baffl e locations
ECO Insert Firebox
Front baffl e
Wetback Brick support lugs
connections
Assembling the fascia (Trend Insert models only)
Trend fascia's are supplied partly assembled, and require the ashlip and
bottom louvre to be fi tted as illustrated in Diagrams 3 and 3A below. To
assemble, proceed as follows: -
• On a large fl at, clean and soft surface (carpet fl oor) slide the fascia out
of the carton, front face down and remove the door which is packed
into a separate carton located in the centre of the fascia. Close the
fl aps of the fascia carton and lay the fascia front down on top of this
now empty carton
• Remove the two sections of tape securing the ashlip panel to the rear
face of the fascia as detailed in Diagram 3. Carefully lift the ashlip
panel away from the fascia and place it gently to one side
• Remove the four screw's and bottom louvre as illustrated in Diagram 3.
4
Rear baffl e
Side brick Wetback
connections
Diagram 3
Door Carton
Bottom
Louvre
Ashlip
LTD Insert Firebox
Front baffl e Rear baffl e
Brick support lugs Side brick
• Reposition the ashlip into its fi nal position as illustrated in Diagram 3A
taking particular attention to ensure:
- The ashlip is the right way around
- Do not mark the coating on the ends of the ashlip panel as you
slide it into the fascia, you may need to slightly prise apart the
fascia side panels as you fi t the ashlip.
• Position the bottom louvre as illustrated in Diagram 3A and refi t the
four screws previously removed.
The fascia is now completely assembled and ready for installation. When
moving the fascia, hold it at both sides to avoid 'twisting' the fascia which
may cause the enamel to chip.
Smart Insert & LTD Smart Insert Firebox
Front baffl e
Wetback Brick support lugs
connections
Bottom
Louvre
Ashlip
Diagram 3A
Rear baffl e
Side brick